Keep ionizer wires tight. Reduce arcing. Restore capture.
- Set of 20 OEM springs that connect and tension ionizer wires in the electronic cell.
- Fix common issues like wire sagging or loose/broken wires that cause popping and poor performance.
- Correct fit for Smokeeter SE‑40 and SE‑50—no guessing on size.
Best for: lounges, bars, bingo halls and shops running SE‑40/SE‑50 units that need quick, low‑cost restoration of ESP performance.
In the Box & Installation
- Included: (20) ionizer wire springs for Smokeeter SE‑40/SE‑50.
- Swap overview:
-
- Disconnect power and discharge the ionizer/cell as directed in the manual.
- Remove the cell/ionizer; replace worn springs and restring wires (two springs per wire).
- Reinstall, ensuring wires are straight and properly seated; test for smooth operation.
Set of 20 Ionizer Wire Springs for Smoke Eater Models SE-40 and SE-50
The springs connect the ionizer wires to the collection cell. Sometimes they get lost or stretched out, so it's a good idea to have an extra set on hand.... just in case.
For use in the following Commercial Air Cleaner(s);
- Smokeeter SE-40 Electrostatic Air Cleaner Smoke Eater
- Smokeeter SE-50 Commercial Air Cleaner Smoke Eater
FAQs
Will these springs fit both SE‑40 and SE‑50?
Yes, this is the correct spring set for both models.
How many springs are in each unit?
The SE‑40 unicell uses 10 springs; the SE‑50 ionizer assembly uses 14. This 20‑pack gives you enough to rebuild a cell and keep spares.
When should springs be replaced?
If ionizer wires sag, disconnect, or you notice popping/sparking, inspect for loose/broken wires and tired springs. Replace as needed.
Need help now?
Call 1-800-237-9199, start a live chat, request a call back, or contact us
