Replacement Ionizer Wires - SE-40

Name: Replacement Ionizer Wires - SE-40
Brand: Parker Hannifin Corporation
SKU: 03-0393
Price: 129.0 USD
Availability: InStock

for Smokeeter SE-40

Set of 5 Wires

$129.00

Usually ships in 5 days; up to 10 for some models

Free Shipping

Bulk order? Request a quote

About this product

Restore charging power in minutes

Correct Replacement set for SE‑40 unicell—no trimming or guessing
Fix sagging/broken wires that cause arcing and weak capture
Works with existing springs (uses two springs per wire)

Set of 5 Replacement Ionizing Wires for Smokeeter SE-40 Electrostatic Air Cleaner Smoke Eater

If you're noticing that your Smokeeter SE-40 Unicell is not functioning properly, you may want to check the ionizer wires. If they're bent, broken, or discolored, they will need to be replaced. It's always a good idea to keep an extra set on hand.... just in case.

For use in the following Commercial Air Cleaner:

Smokeeter SE-40 Electrostatic Air Cleaner Smoke Eater

Best for

Lounges, bars, bingo halls, and retail shops operating Smokeeter SE-40 air cleaners
Facilities that need a quick, low-cost refresh of ionizer performance
Replacing worn or arcing ionizer wires to restore proper particle charging
Smoke-heavy environments requiring consistent electronic air cleaning
Routine maintenance programs focused on keeping Smokeeter SE-40 units running efficiently

Specifications

What's in the box

Set of 5 replacement ionizer wires designed specifically for the Smokeeter SE-40

Installation tips

Power Off the Unit: Turn off and unplug the Smokeeter SE-40 before servicing.
Open Access Door: Remove or open the access panel to reach the ionizer and unicell assembly.
Discharge Components: Manually discharge the ionizer and unicell using the proper grounding procedure as shown in the unit instructions.
Remove Old Ionizer Wires: Carefully remove the existing ionizer wires from the unit.
Install New Ionizer Wires: Attach the new ionizer wires using two springs per wire (springs not included), ensuring proper tension and alignment.
Reinstall Unicell: Reinstall the unicell assembly in its original position.
Close and Test: Close the access door, restore power, and test the unit for proper operation.

Always follow the Smokeeter SE-40 service instructions and grounding procedures to ensure safe installation and proper performance.

Frequently asked questions

Does this fit my Smokeeter SE-40?
Yes. This is the correct replacement ionizer wire set (03-0393) designed specifically for the Smokeeter SE-40 unicell.

What’s the difference between ionizer wires and ionizer wire springs?
Ionizer wires are the tungsten charging wires that create the electrical field needed to charge airborne particles for capture. Ionizer wire springs are the tensioning components that hold those wires in place and keep them properly stretched. Wires are replaced when they are worn, broken, or arcing, while springs are replaced when they lose tension or during a full wire replacement to ensure proper alignment and performance.

How many ionizer wire springs do I need?
You need ten springs total . The SE-40 unicell uses two springs per wire. Ordering the Ionizer Wire Springs — Set of 20 is also recommended so you have spares on hand.

What are the ionizer wires made of?
The Smokeeter SE-series ionizer uses fine tungsten wires supported between plates for effective particle charging.

How do I know when the ionizer wires need to be replaced?
Replace the wires if they are bent, broken, or discolored, or if you notice arcing, popping sounds, or reduced air cleaning performance.

Do these work with the Smokeeter SE-50?
If you have an SE-50, order the SE-50 Ionizer Wires — Set of 9, which use a different wire count and length than the SE-40.